Tool set 1626.1A is used together with 1626/2 Campagnolo Ultra Torque bearing removal and installation set. It's used to remove the Power Torque standard cranks and install & remove bearings on this crank.
Use it together with the a 1/2" ratchet. For Shimano® and ISIS® bottom brackets.
Use it together with the a 1/2" ratchet. For Shimano XTR BB-950, Bontrager, Truvativ, ISIS bottom brackets.
This tool supports Shimano® Hollowtech II, Campagnolo® Ultra-Torque and Power Torque, Race Face®, FSA®, SRAM®, Truvativ®, Chris King® as well as many other bottom brackets.
This tool supports Campagnolo® Ultra-Torque bottom brackets.
This tool supports Truvativ bottom brackets.
The double threaded screw enables you to use this tool for Shimano standard bottom brackets as well as for Shimano Octalink and ISIS bottom brackets.
This tool is designed to remove the non-threaded bottom bracket bearings of the BB30 bottom bracket system. The removal tool will safely drive the bearings out of the BB30 bottom bracket shell.
This tool is designed to remove bearings and cups of the BB90 bottom bracket system. It also supports other press fit standards with 24 mm spindle, such as BB86, BB92, SRAM Press Fit GXP.
Designed and built to install and remove the pressed bearing used on Campagnolo® and Fulcrum® Ultra-Torque cranks.
Please use the following characteristics in order to narrow down your product results.
Continue by clicking "use filter" to carry out the filter