The puller is a tool for quickly and precisely removing the headset crown race from 1", 1-1/8", 1-1/2" or 1-1/4" suspension or rigid front fork.
The crown race setting system is intended for crown race installation on the steerer tube to fit 1’’, 1-1/4’’, 1-1/8’’, 1-1/2" diameters.
This tool is used for removal of headsets of older bike models. To remove the ball bearing cups, tap on the tool with hammer.
The head set cup remover makes removal of cups 1", 1-1/8" and 1-1/4" from the frame easy.
The head set cup remover makes removal of cups 1-1/4" and 1-1/2" from the frame quick and easy.
The threadless nut setter is used to install the star fangled nut found on 1" and 1-1/8" threadless headset systems. It is intended for both professionals and home users.
The guide is designed for guiding the threadless nut setter when installing star nuts found on 1" and 1-1/8" threadless headset systems. It is intended for both professionals and enthusiasts.
This tool accurately presses headset cups 1”, 1-1/8”, 1-1/4 ” and 1-1/2” into head tubes. In addition it has a longer spindle for BMX headsets with larger tubing.
The design of the offset cone wrench enables working in difficult hard to reach places. This unique design is suitable for assembly and disassembly of nuts on Sun Tour headsets.
To use, remove the wheel and insert the tool into the frame. This tool is used for the alignment of the rear triangle and dropouts.
Please use the following characteristics in order to narrow down your product results.
Continue by clicking "use filter" to carry out the filter