The RESET PF30 bottom bracket allows the mounting of BB30 cranks on frames with Pressfit 30 housing. The bottom bracket is completely sealed against water and dirt, very lightweight and available in different colors. For maintenance, it can be completely disassembled.
- material: aluminum 7075, steel, POM, NBR
- bearing: deep groove ball bearing
- seal: radial shaft seals, O-rings
- surface: anodized and laser-engraved
- case width: 83 mm
PF30 is a variant of the BB30 design. The PF 30 design uses BB30 size bearings pre-installed in bearing cups. The bearing and cup are pressed into the PF30 bottom bracket shell.
Only suitable for BB30 cranks. Not compatible with cranks, which have a 30 mm axle in junction with external bearings or larger bearing intervals. Not compatible with Hollowtech II and GXP cranks.