After RESET significantly increased the standard for enduro and downhill pedals with their Pedal3, they want expand into new areas with the fourth creation: trekking, tour, urban, singlespeed and e-bike are the application areas of the all new RESET Pedal4.
High-strength aluminum and stainless steel set up the frame for the Pedal4 - without using a single screw! The laser-cut sheet metal parts are cleverly assembled and clamped with accurately calculated tie rods on the bearing body. Lightweight hollow pins ensure that the sheet metal and aluminum parts remain exactly at the assigned place. The result is a light and strong frame, that can be disassembled for repairs as usual at RESET. Pedal4 - transparent, classic and sassy!
- material: pedal body + screws: 7075 T6 aluminum and stainless steel
- axle: high-strength stainless steel
- bearing: 2 precision ball bearings, 1 needle bearing
- seal: radial shaft seals
- weight: approx. 362 g
- surface: anodized and laser-engraved
- contact area: 78 x 88 mm
- height: 25 mm