Press-Fit Set with Press Tool for Press Fit bearings including 4 sets of pressrings.
Following pressrings are included:
- Campagnolo Ultra-/Power-Torque (inner diameter 23,9 mm and outer diameter 30,0 mm)
- SRAM, Truvativ, GXP (left pressring: inner diameter 21,9 mm and outer diameter 35,5 mm; right pressring: inner diameter 23,9 mm and outer diameter 35,5 mm)
- Shimano BB & FSA (inner diameter 23,9 mm and outer diameter 35,5 mm)
- FSA BB.30 (inner diameter 29,9 mm and outer diameter 38,5 mm)
Press rings will be applied along with a press spindle. Set the bottom bracket cup on the press ring, put both of them on the spindle and insert it in the bottom bracket housing of the frame. Put the second bottom bracket cup on the spindle from the opposite side of the bottom bracket housing. Rotate the threaded sleeve carefully until the cups are pressed in their housing.
Pay attention, that the rings press on the outer edge of the bearing edge and the cups are not jammed during the work. Follow the manufacturer instructions regarding recommended torque moment.