Reverse Components -0.5° DH Angle Spacer 1.5“ reduces to 1 1/8“ - black

With the DH Angle-Spacer (fork cone) for 1.5" head tubes reduced to 1 1/8" stems of double crown forks, the geometry of the bike can be fine-tuned. It is possible to make the steering angle half a degree (-0.5°) flatter, which brings even more performance out of the bike on steep and difficult descents!

The spacer replaces the conventional fork cone and is mounted between the fork crown and headset. It can be used with any headset with 45° ball bearings. (45° ball bearings are used in 95% of all bikes) The DH Angle Spacer is wider than the standard 1 1/8 Spacer (Ø 62mm) and fits perfectly to wide 1.5" head tubes.

To use the Angle Spacer, simply take the fork out of the frame and then remove the existing fork cone / crown race from the fork crown. The Angle-Spacer is mounted directly above the fork crown where the old fork cone / Crown Race was before. Using the Angle-Spacer does not change the stability and stiffness of the fork in any way. It can be mounted on any bike without hesitation. So you get a more modern geometry with more riding fun and safety.

Features of the Reverse Components -0.5° DH Angle Spacers

• installation height: 10 mm
• Weight: 61 g (+/- 5 % weight tolerance)
• Outside diameter 61.0 mm
• Inside diameter 1 1/8
• Material: aluminium