Reverse Components -0.5° Angle Spacer 1 1/8"

With the Reverse Components Angle-Spacer (fork cone) for 1 1/8" forks the geometry of the bike can be modernized and fine-tuned. It is possible to make the steering angle half a degree (-0.5°) flatter, which allows you to get even more performance out of the bike on steep and difficult descents!

The spacer replaces the conventional fork cone and is mounted between the fork crown and headset. The Angle-Spacer can be used with any headset with 45° ball bearings. (45° ball bearings are installed in 95% of all bikes)

To use the Angle Spacer, simply take the fork out of the frame and then remove the existing fork cone / crown race from the fork crown. The Angle-Spacer is mounted directly above the fork crown where the old fork cone / Crown Race was before. The use of the Angle-Spacer does not change the stability and stiffness of the fork in any way. It can be mounted on any bike without hesitation. So you get a more modern geometry with more riding fun and safety.

Features of the Reverse Components -0.5° Angle Spacers

• installation height: 10 mm
• Weight: 33.8 g (+/- 5 % weight tolerance)
• Outer diameter 51.0 mm
• Inside diameter 1 1/8
• Material: aluminium