Profile Design Wedge Kit - ASC Pro | Angle Element for Extensions - negative (-1° to -5°)

The wedges, specifically designed for Profile Design's ASC Pro extensions, allow for precise adjustment of the standard angle. The "tilt wedges" are available with both positive and negative angles ranging from 1 to 5 degrees, allowing the initial angle of 15 degrees to be reduced or increased as desired. For safety reasons, the entire adjustment range is limited to +/- 10 degrees, meaning that the maximum achievable angle is 25 degrees and the minimum is 5 degrees.

Technical details of the Profile Design ASC Pro wedge kit

• angle: 1° / 2° / 3° / 4° / 5° (positive or negative)
• compatibility: ASC Pro extensions (A3 riser system)
• weight: approx. 10 g (per pair; manufacturer's specification)

Scope of supply:

5 pairs of wedges (2 per angle, left + right)

Installation note: When using the "switch adapters" included with the ASC Pro Extensions, please note that these reduce the "reach" by 20 mm when the brackets are attached upside down. The angle of the wedges is also reversed accordingly.